GSI Laser 225.596.07

Specialized Electronics Services Repairs All Laser Parts.

CALL US TODAY TOLL FREE: 1-800-681-7374

GSI 225.596.07 – Sbus-Multibus Adapter

GSI 225.596.07 - Bit3 Board MultiBus

gsi laser

The Sbus-Multibus adapter card provides a backplane connection between the host computer and the M310 laser trim system. The adapter is a two-card set with one card interfacing to the Sbus installed in the host computer and the other (interfacing to the Multibus I backplane) located in card cage slot A10. The two cards are connected via a special data cable, allowing the computer to act as the Multibus master. Address mapping permits the Sbus to directly access Multibus memory as though it were local to the computer controller.
Further information can be found in Section 3.5. Two red LEDs on the Sbus-Multibus adapter card are used to indicate device status: • LED 2 (labeled “CEN” on the card) is ON when the card sees a 0 on the BPRN line. Thus LED 2 should always be ON if the system has power. • LED 1 (labeled “CMD” on the card) blinks when data is being transferred between the system computer and the I/O bus.

In order to minimize the time required to perform maintenance or repairs on your system, it is advisable to maintain a local supply of spare parts.

The quantity and nature of these spare parts is determined by the Periodic Maintenance requirements of the system, and by the number of systems that are installed at your location.

It may also be important to consider the difficulty of shipping components to your location. Spare parts can be ordered either through Specialized Electronic Services. Toll free phone numbers are available. Call Now!

You can also email inquiries regarding the availability of spare parts can be addressed to:

Note: When ordering parts such as galvanometers, lasers or expensive optics, consult SES before you consult other vendors. SES has years of experience and will give you the best pricing and service in the industry.

SES – CALL NOW TOLL FREE: 1-800-681-7374