Specialized Electronics Services Repairs All Laser Parts.

 CALL US TODAY TOLL FREE: 1-800-681-7374

TS378 Fastblaster Controller Card

gsi laser

Each TS378 can provide the following functions: Solenoid Drivers – There are eight solenoid drivers on each TS378 board. Each driver consists of a single Darlington power transistor whose output is currentlimited to approximately 1.0 Amp. The drivers are protected for fast negative transition of up to -50 Volts (to block back EMF generated by solenoid coils). The eight driver transistors are arranged as two sets of four drivers. They are referred to as the ’A’ drivers and ’B’ drivers. Each set of four drivers is configured to supply the same voltage level. The drivers can be used to supply equal amplitude pulses to a four-phase stepper motor. Each set of solenoid drivers (A and B) can be configured to supply either +12 Volts or +24 Volts DC. The voltage supply to the driver transistors is determined by back plane input wiring for each TS378 board. Thus, the TS378s are fully interchangeable for troubleshooting purposes. Overload Protection – In addition to current-limiting resistors on the output of each driver, there is thermal overload protection on each TS378 for the ’A’ driver transistors. A bi-stable thermoswitch containing the power driver transistors is mounted on the heatsink. (The ’A’ drivers are normally configured to supply +24 Volts.) If the ’A’ drivers become overloaded, the temperature of the heatsink will rise. The thermoswitch will open when the heatsink temperature reaches 65° C. This disconnects the common return line for the ’A’ driver transistors. A green LED on each TS378 (see Figure 3-15) indicates the status of the ’A’ driver set. The LED is lit during normal operation, and turns off when the thermoswitch opens.

In order to minimize the time required to perform maintenance or repairs on your system, it is advisable to maintain a local supply of spare parts.

The quantity and nature of these spare parts is determined by the Periodic Maintenance requirements of the system, and by the number of systems that are installed at your location.

It may also be important to consider the difficulty of shipping components to your location. Spare parts can be ordered either through Specialized Electronic Services. Toll free phone numbers are available. Call Now!

You can also email inquiries regarding the availability of spare parts can be addressed to:

Note: When ordering parts such as galvanometers, lasers or expensive optics, consult SES before you consult other vendors. SES has years of experience and will give you the best pricing and service in the industry.

SES – CALL NOW TOLL FREE: 1-800-681-7374